1
CPW001_F1
EN
ASSEMBLY & USE
Assemble both straw
pieces firmly together.
Pull through lid until
straw snaps into place.
rubber collar
is visible
when straw is
snapped
in place
collar
NO rubber collar is
visible
when straw is
not fully snapped
no collar
If using separate handles, assemble with cap before tightening onto cup - connect notches in handles with structure under
cap. Fill cup and tightly screw cap, with or without handles, onto cup.
CLEANING
Before using, wash in hot soapy water & rinse well – if possible, wash in dishwasher for best results.
Wash cup immediately after every use. Avoid overly aggressive cleaning of any parts to prevent damage to
sealing surfaces. Do not boil or microwave to sterilize parts. All parts are dishwasher safe, top rack only.
For Your Child’s Safety and Health
WARNING!
Always use this product with adult supervision. Continuous and prolonged sucking of fluids will cause tooth
decay. Always check food temperature before feeding. Hot or carbonated liquids are not recommended. Due
to the risk of hotspots and over-heating, use of a microwave oven is not recommended. Always use transition
cup with valve installed. The transition cup will not function properly without it. The spout must be clean and
free of obstructions. Keep all components not in use out of the reach of children. Before each use, inspect all
components for wear or damage. To prevent a possible choking hazard, test the strength of the valve and
straw regularly by pulling hard and checking for cracks or wear. If any component becomes cracked, torn or
shows other signs of excessive wear, discontinue use immediately and discard worn or damaged parts.
Always use with adult supervision and do not leave child unattended with the cup. Do not allow a child to
walk or run while using the cup. Do not leave the product in direct sunlight or heat, store in a dry environment.
Straws are not suitable for a child under 6 months.
