VigorSwitch G1260 User’s Guide
67
Packet Per Second
It is a threshold. When the broadcast packet traffic in a
second is higher than the threshold configured, the
Broadcast Strom Protection enable.
Unlock Time
The period (in seconds) for which a port will be kept
disabled in the event of a loop is detected (and the port
action is to shut down the port).
Port
Display the number of the ports on the switch.
State
Show the status on the port.
Protocol Enabled
Controls whether Broadcast Strom Protection is enabled
on this switch port.
Unlock port
When ticking the port, port locked will be opened and
turned into unlocked. If not ticking the port, Port
maintains locked.
3
3
.
.
1
1
2
2
S
S
N
N
M
M
P
P
Any Network Management System (NMS) running the Simple Network Management
Protocol (SNMP) can manage the Managed devices equipped with SNMP agent, provided
that the Management Information Base (MIB) is installed correctly on the managed devices.
The SNMP is a protocol that is used to govern the transfer of information between SNMP
manager and agent and traverses the Object Identity (OID) of the management Information
Base (MIB), described in the form of SMI syntax. SNMP agent is running on the switch to
response the request issued by SNMP manager.
Basically, it is passive except issuing the trap information. The switch supports a switch to
turn on or off the SNMP agent. If you set the field SNMP “Enable”, SNMP agent will be
started up. All supported MIB OIDs, including RMON MIB, can be accessed via SNMP
manager. If the field SNMP is set “Disable”, SNMP agent will be de-activated, the related
Community Name, Trap Host IP Address, Trap and all MIB counters will be ignored.
Function name:
SNMP Configuration
Function description:
This function is used to configure SNMP settings, community name, trap host and public
traps as well as the throttle of SNMP. A SNMP manager must pass the authentication by
identifying both community names, then it can access the MIB information of the target
device. So, both parties must have the same community name. Once completing the setting,
click
<Apply>
button, the setting takes effect.
