Draytek Vigor2930 Series, User Manual

Page: 12 / 298

Vigor2930 Series User’s Guide 4
1 1 . . 2 2 . . 2 2 F F o o r r V V i i g g o o r r 2 2 9 9 3 3 0 0 n n
LED Status Explanation
Blinking The router is powered on and running normally. ACT (Activity)
Off The router is powered off.
On The DoS/DDoS function is active. DoS
Blinking It will blink while deleting an attack.
CSM On The profile of CSM (Content Security
Management) for IM/P2P application is active. (It
is enabled from
CSM >> IM/P2P Profile ).
On
Wireless access point is ready.
WLAN
Blinking
It will blink while wireless traffic goes through.
It will blink fast when WPS is working and it will
return to normal condition after two minutes.
(You need to setup WPS within 2 minutes.)
On The WAN1 or WAN2 port is connected. WAN1/2
Blinking It will blink while transmitting data.
On The router is managed (handled) by Telnet. MGMT
Blinking It will blink while being managed by IE browser.
VPN On The VPN tunnel is active.
QoS
On The QoS function is active.
LED on Connector
On The port is connected.
Off The port is disconnected.
Left LED
(Green)
Blinking The data is transmitting.
On The port is connected with 100Mbps.
WAN 1/2
Right LED
(Green)
Off The port is disconnected with 10Mbps.
On The port is connected.
Off The port is disconnected.
Left LED
(Green)
Blinking The data is transmitting.
On The port is connected with 100Mbps.
LAN 1/2/3/4
Right LED
(Green)
Off The port is disconnected with 10Mbps.
Interface Description
Factory Reset Press "Factory Reset" button once to make network connection through WPS.
Press "Factory Reset" button twice to enable or disable WLAN function.
Press "Factory Reset" button for 5 seconds to do the factory reset.
Restore the default settings. Usage: Turn on the router (ACT LED is blinking).
Press the hole and keep for more than 5 seconds. When you see the ACT LED
begins to blink rapidly than usual, release the button. Then the router will restart
with the factory default configuration.
Restart Restart the router forcefully.
Phone (1/2) Connecters for PSTN phones.
WAN (1/2) Connecters for remote networked devices.