page 6 of 7
SmartTrim™ for
UniSee
®
Edge Mounting
Bracket
Alignment
Tool
LCD
Panel
LCD
Panel
LCD
Panel
LCD
Panel
LCD Seam
Aligned with
Bracket Center
LCD Seam
Aligned with
Bracket Center
Loosen
Set Screws
to Adjust
SmartTrim Bracket Adjustments
Section 6 -
Adjusting SmartTrim Brackets
Please Note:
Figures 5-A thru 5-C below show an edge bracket on the side of the Unisee.
The same procedure shown below should be used on the top and corners.
SmartTrim Adjustable Bracket is always aligned with the vertical center of the UniSee Wall Cross.
During installation of the Unisee Video Wall, the position of the LCD seam may have moved in relation to the Wall Cross.
Draper SmartTrim adjustable brackets are designed to move both vertically and horizontally to ensure realignment with the LCD Panels.
To adjust the SmartTrim Brackets:
1.
Attach the alignment tool to the SmartTrim Bracket
(see Fig. 5-A)
.
2.
Ensure that the notch aligns with the seam of the LCD panel
(see Fig. 5-B)
.
If the notch does not align with the seam, loosen the set screws in the bracket
(see Fig. 5-C)
and reposition the bracket until it is aligned
(see Fig. 5-B)
.
3.
Once aligned, retighten set screws.
4.
Repeat until all brackets are aligned with the closest LCD seam.
5.
Install the SmartTrim sections according to Section 5 - Attaching SmartTrim
sections to SmartTrim Brackets
Figure 5-A
Figure 5-B
Figure 5-C
Summary of Contents for SmartTrim
Page 8: ......
