background image

Motor

Black (Down)

Dashed wiring 
by electrician

Control
switch

N

O

To 220v

50 Hz. Line

Blue (Common)

Brown (Up)

Green (Ground)

White

Black

N

DN

UP

Neutral

L1

220 V Micro Projector Lift by Draper, Inc.

page 4 of 4

Wiring Diagrams

Single Station Control

(CE Approved)

Low Voltage (& Wireless) Control

(CE Approved)

Multiple Station Control

(Not CE Approved)

Motor

Black (Down)

Dashed wiring 
by electrician

Blue

Black

Red

N

O

To 220v 50 Hz. Line

Blue (Common)

Brown (Up)

Green (Ground)

White

Black

N

DN

UP

Blue

Red

Blue

Red

Black

Black

Cap off with
wire nut 
and tape

Neutral

Hot

Motor

Black (Down)

Dashed wiring 
by electrician

N

O

To 220v

Line

Blue (Common)

Brown (Up)

Green (Ground)

White

Black

N

DN

UP

STOP

Control 
Switches
24v DC

Black (DN)
Red (UP)
White (COM)

Black (DN)
Red (UP)
White (COM)

STOP

Black 
Red 
White 

White

Brown

Red

Black

Yellow

Green

Low Voltage Control Module

Optional Infrared
Receiver Package

Optional
Radio 
Receiver
Package

220v, 50 Hz.

All-Pole Disconnect
by Others

Summary of Contents for Micro projector lift

Page 1: ...trical codes All operating switches should be off before power is connected Micro Projector Lift should be operated and checked prior to installing projector and or optional ceiling closure Caution Read instructions completely before proceeding Follow instructions carefully Installation contrary to instructions invalidates warranty Do not obstruct operation of Micro Projector Lift with fingers or ...

Page 2: ...ll the plenum housing in a pre assembled state or as separate components which will require that the plenum housing be completely disassembled prior to installation Please Note If the plenum is to be installed in a space where there is no access from above the plenum then it is recommended that the Micro projector Lift be installed to the upper section prior to installing the plenum housing Please...

Page 3: ...with nuts above and below slots Run unit up again to highest position Measure distance by which panel fails to reach required closed height for surrounding ceiling Run unit down then readjust mounting of 5 16 18 rods in traveling grid to raise panel required distance Test unit operation to confirm that panel will stop in closed position just before touching ceiling NOTE Immediately upon completion...

Page 4: ...by electrician Blue Black Red N O To 220v 50 Hz Line Blue Common Brown Up Green Ground White Black N DN UP Blue Red Blue Red Black Black Cap off with wire nut and tape Neutral Hot Motor Black Down Dashed wiring by electrician N O To 220v Line Blue Common Brown Up Green Ground White Black N DN UP STOP Control Switches 24v DC Black DN Red UP White COM Black DN Red UP White COM STOP Black Red White W...

Reviews: