SkyLight 3 Installation Instructions
3
of
6
(765) 987-7999
www.draperinc.com
Part Three: Installing Roller Fabric Assembly -
(2 installers REQUIRED)
(1)
Lift the entire
Roller Assembly up near the Motor Mounting Brackets and
insert the
Hem Bar Rollers into the Side Channels (see Fig. 9).
Be sure to continuously pull the excess
Motor Cable through the Cable Exit.
(2)
With the
Hem Bar inserted into both of the Side Channels, lift the Roller
Assembly up until the Lower Sections of the Motor Mounting Brackets
(attached to the ends of the
Roller Assembly) are completely engaged with
the
Upper Sections (mounted to the skylight frame).
(3)
Re-tighten the four (4) screws (2 per bracket) using a Hex Wrench.
Installing Roller/Fabric Assembly
Part One: Attaching Lower Sections of Motor Bracket (see fig. 7)
(1)
Remove the
Motor Ring from the Motor on the end of the Roller Assembly.
(2)
Feed the
Motor Cable through the Operator side of the Motor Mounting
Bracket.
(3)
Attach the
Operator Mounting Bracket to Motor and secure with Motor Ring.
(4)
Attach the
Idler Mounting Bracket.
WARNING :
The following procedure REQUIRES at least two (2)
installers to preform safely.
Part Two: Motor Cable Routing (see fig. 8)
(1)
Feed
Motor Cable through the Cable Exit hole (See Cable Exit Step
(1)
).
(2)
Route the
Motor Cable toward the back of the Motor Mounting Bracket
as shown in Fig. 8. This will ensure that the
Motor Cable does not interfere
with the shade while in operation.
C
Feed Motor Cable
through the Operator
side of the Motor
Mounting Bracket
B
Remove
Motor Ring
D
Attach Bracket to Motor
and Secure with Motor Ring
E
Attach Idler Bracket
Hem Bar
Roller
Assembly
Idler End
Roller
Assembly
Operator End
Figure
(7)
C
Route Motor Cable
toward the back of
the bracket as shown
B
Feed Motor Cable
through the Cable
Exit hole
Roller
Assembly
(Operator End)
Figure
(8)
WINDOW
FRAME
WIDTH
B
Insert Hem Bar
Rollers into
Side Channels
INSERT ROLLERS
HEM BA
R
HEM
BAR
Figure
(9)
Roller
Assemb
ly
HEM
BAR
C
With the Hem Bar inserted into
the both of the Side Channels,
Lift the Roller Assembly up until the
Lower Sections of the Motor
Mounting Brackets are engaged with
the Upper Sections.
D
Re-tighten the four (4)
screws (2 per bracket)
using a hex wrench.
Figure
(10)
