Draper D13/5A, Instructions Manual

Page: 7 / 20

ADDITIONAL SAFETY RULES FOR DRILL PRESSES
- 7 -
1. This drill press is intended for use only with
drill bits. The use of any other accessories may
be hazardous.
2. CHECK to see that the drill bit is securely
locked in the chuck.
3. CORRECT DRILLING SPEEDS
Important factors which determine the best
speed to use in any drill press operation are:
a) The smaller the drill the greater the
required r.p.m. (revolutions per minute)
b) In soft materials the speed should be
higher than for hard materials.
4. MAKE sure that the chuck key is removed
before turning on the power.
5. CHECK to see that the chuck is securely
fastened to the spindle.
6. CAUTION. When practical, use a vice or
clamps to secure workpiece to avoid work-
piece rotating with the drill bit.
7. SECURE the tool to a workbench of floor. If
during operation there is any tendency for the
drill press to tip over, slide or walk on the
supporting surface, the drill base must be
secured to the supporting surface with
fasteners through the holes located in the drill
press base.
8. For your safety DO NOT wear gloves when
operating a drill press.