16
8 ASSEMBLY
– Remove the plastic transit spacer
.
– Position the guide bar
onto the stud bolt
.
– Reposition clutch cover
, ensuring rear end is
hooked in place correctly.
– Using
screwdriver
adjust chain adjustment
screw
until clutch housing clicks in place –
this aligns chain adjustment pegs with the
aperture in the chain bar.
– Refit screws and nut on clutch cover.
– Re-tighten guide bar locking nut
using the
combination box spanner
.
– Using the hex key
replace and tighten the
M6 hex screws.
FIG.6
FIG.5
FIG.7
FIG.8
Summary of Contents for CSP2625
Page 35: ...35 NOTES ...
