3. GUARANTEE
3.1 GUARANTEE
Draper tools have been carefully tested and inspected before shipment and are guaranteed to be
free from defective materials and workmanship.
Should the tool develop a fault, please return the complete tool to your nearest distributor or
contact:
Draper Tools Limited, Chandler's Ford, Eastleigh, Hampshire, SO53 1YF. England.
Telephone Sales Desk: (023) 8049 4333
or:
Product Helpline (023) 8049 4344.
A proof of purchase must be provided.
If upon inspection it is found that the fault occurring is due to defective materials or workmanship,
repairs will be carried out free of charge. This guarantee period covering parts/labour is 12 months
from the date of purchase except where tools are hired out when the guarantee period is 90 days
from the date of purchase. This guarantee does not apply to normal wear and tear, nor does it
cover any damage caused by misuse, careless or unsafe handling, alterations, accidents, or
repairs attempted or made by any personnel other than the authorised Draper warranty repair
agent.
Note: If the tool is found not to be within the terms of warranty, repairs and carriage charges will be
quoted and made accordingly.
This guarantee applies in lieu of any other guarantee expressed or implied and variations of its
terms are not authorised.
Your Draper guarantee is not effective unless you can produce upon request a dated receipt or
invoice to verify your proof of purchase within the guarantee period.
Please note that this guarantee is an additional benefit and does not affect your statutory rights.
Draper Tools Limited.
11. MAINTENANCE
11.1 MAINTENANCE
- OIL
Please check the oil level every 4 months. The oil capacity is about 0.3lt. Use the
hydraulic type oil according to the temperature scale below.
-
EXPELLING AIR FROM THE PUMP UNIT
Air may come into contact with the hydraulic oil because of transportation or pump in
upset position. It can cause the forks to be unable to elevate while pumping in the
RAISE position. Release the air in the following way: select the control handle on the
LOWEST position, then move the handle up and down several times.
-
DAILY CHECK AND MAINTENANCE
Check the overall condition of the pallet truck daily.
Keep clean and lubricate all
moving parts at regular intervals,
special attention should be paid to the wheels, axles,
threads etc. The forks should be unloaded and lowered in the lowest position when the
job is complete.
- LUBRICATION
Use motor oil or grease to lubricate all moveable parts.
Temperature
Oil
-20°C ~ +40°C
Hydraulic oil
- 4 -
- 13 -