Draper 64097, Instructions Manual

Page: 9 / 16

- 8 -
ADJUSTMENTS & OPERATION
Wheel height adjustment
Warning
Before adjusting wheel assembly, ensure that
your mower is disconnected from the mains.
Each of the two axle wheels has its own means
of height adjustment, which gives three cutting
height positions.
To select a cutting height, move the wheel
✪✌
into the slot required using the spring system
✫✌
.(Fig.5)
Adjust the other three wheels in the same way.
To ensure an even cut, please make sure that all
four wheels are set to the same position,
however in some situations having the front
wheels one notch lower than the rear wheels
may produce a better result.
Operation
1. Adjust the wheel height if required.
2. Fit the grass box.
3. Connect the mower Fuse Key
✬✌
(Fig.6).
4. The mower is equipped with an electrical
safety switch to protect against accidental
starting and a motor brake to stop the motor
in less than three seconds once the switch is
off.
5. To start the mower depress the safety lock-
off button
✭✌
on the switch box, and whilst
still depressed pull the switch lever
✮✌
(Fig.7). The mower will start.
To stop the mower release the lever. The
brake will operate and the mower will stop
in less than three seconds.
Fig.5
Fig.6
Fig.7
✪✌
✫✌
✬✌
✭✌
✮✌