Draper 56479, Instructions Manual

Page: 8 / 12

- 7 -
OPERATION & USE
OPERATING THE GRASS TRIMMER
(Fig.4.)
There is only one way of inserting the battery.
Insert the charged battery in to the grass trimmer
until both side push-buttons lock in.
Take a safe standing position. Hold the grass
trimmer with both hands. Do not put the cutting
head on the ground.
Press switch
✕✌
to start the machine. Release the
switch to stop the machine.
ADJUSTING THE SPOOL (Fig.5.)
Whenever the cutting performance decreases, it is
necessary to adjust (to extend) the nylon spool.
Turn the grass trimmer on and hold it above the
grass.
With the motor running, knock the head on the
grass. The spool will automatically extend and the
cutting device will reduce it down to the correct
length.
NOTE: If the spool is shorter than 2.5cm, it is
necessary to adjust it manually. Remove the
battery, press the red push-button on the coil until
it reaches the stop and pull the end of the spool. If
you cannot see the end of the spool at all, proceed
as described in the next section.
REPLACING THE NYLON SPOOL (Fig.6 & 7.)
Take the battery out of the grass trimmer and turn
the machine around.
Take hold of the cover
✕✌
(Fig.6.).
Push both tabs in the direction indicated by the
arrow (Fig.6.).
Turn the locking part
✖✌
anti-clockwise
(Approximately by 2cm) and take it off.
Take the coil with the spool
✗✌
out of the locking
part (Fig.6.).
Pull the end of the spool through the opening in
the locking part (Fig.7.).
Fit the new spool in the locking parts.
Mount the locking part with the new spool on the
cover and lock it in by rotating it clockwise. The
click of both tabs must be audible.
Fig.4.
Fig.5.
Fig.6.
Fig.7.