UNPACKING
ASSEMBLY
- 7 -
IMPORTANT:
To correctly assemble and adjust this wood lathe,
please read the following instructions carefully.
NOTE:
To secure the wood lathe to the workbench/stand you
will need to obtain the following nuts, bolts and
washers:- (THESE ARE NOT SUPPLIED).
4 x
5
⁄
16
″
x 2
″
bolts and nuts,
4 x
5
/
16
″
lockwashers,
4 x
5
/
16
″
standard washers,
1 x
1
/
4
″
x 3
1
⁄
2
″
long hex. head bolt and nut,
1 x
1
/
4
″
standard washer,
1 x
1
/
4
″
lockwasher,
3 x wood or self-tapping screws.
SECURING THE HEADSTOCK TO THE
WORKBENCH/STAND
Note: Position your wood lathe on the workbench/
stand before drilling location holes, this will ensure a
totally correct alignment.
Mark and drill two 9.5mm (
3
/
8
″
) holes
✪✌
Fig.2. in the
top of the workbench/stand as shown in Fig. 2.
Ensure the headstock is positioned so you do not
drill into the legs or support rails underneath.
Call the Power Division Helpline (01703) 494344 if you have any enquiries, eg. problems
with assembly, apparent missing/damage parts, help with accessories available or
technical advice.
Carefully unpack the wood lathe and all the loose parts from the carton. Fig.1. illustrates the wood lathe
and all the associated parts that are packed in the carton. Check that all the parts are present.
Fig.1.
Fig.2.
105mm (4
1
⁄
4
″
)
35mm (4
3
⁄
8
″
)
155mm (6
19
⁄
64
″
)
