- 7 -
ASSEMBLY
To correctly assemble, fit and adjust the tool
rests, spark deflectors and eye shields.
Carefully follow these instructions:
TOOL RESTS.
Attach the left and right hand tool rests
✪✌
using the four bolts
✫✌
and large washers
✬✌
as shown in Fig.3. Now adjust the tool rests so
there is approximately a 1.5mm (
1
⁄
16
") gap
between the surface of the grinding wheels
and the tool rests.
SPARK DEFLECTORS
Attach the two spark deflectors
✭✌
using the
two bolts
✮✌
and medium size washers
✯✌
as
shown in Fig.4. Now adjust the spark deflectors
so there is approximately a 1.5mm (
1
⁄
16
") gap
between the surface of the grinding wheels
and spark deflectors.
EYE SHIELDS
Place the eye shield frame
✰✌
over the eye shield
✱✌
fasten the
two parts together using the long
screws
✲✌
, washers
✳✌
and nuts
✴✌
. See Fig. 5.
Note: Do not overtighten as the
eye shield may crack.
Assemble the other eyeshield in
the same way.
Insert the shortest end of the
mounting rod
✵✌
Fig.6 into the
hole
✶✌
in the shield frame
✷✌
.
Now tighten the nut
✸✌
and round
headed bolt which are located in
the centre of each of the eye shield
mounting frames
✹✌
. Fig.7 shows
the assembled eye shield
assembly.
✪✌
✱✌
✴✌
✳✌
✲✌
✵✌
✶✌
✷✌
✸✌
✯✌
✰✌
✹✌
Fig.3.
Fig.4.
Fig.5.
Fig.6.
Fig.7.
✫✌
✬✌
✮✌
✭✌
