8.3 FRAME ASSEMBLY – FIG.5
For transportation and delivery purposes, the handle
part of the frame section
needs to be fitted
before use (see Fig.5).
– Re-fit the handle frame to the back support
frame using the existing 4 × M8 × 75mm
bolts and nuts
.
– Fasten to finger tightness, then finish tightening
with a pair of spanners
(not supplied).
8.4 INSTALLING WHEELS – FIG.6
– Slide each of the wheels
over the axles.
– Using a spanner
(not supplied)
fasten each
wheel in place with a washer and
M8 × 15mm bolt
.
8.5 ATTACH PIVOT BRACKET
– FIGS.7 – 8
– Remove the pivot bracket
from the stand
and offer it up to the axle bracket on the cement
mixer.
– Attach with pivot pins
, then slide split pins
through to secure the pivot bracket in
place.
– The
safety
pin
is inserted through the hole
in the bracket to prevent the drum falling
forward.
6. TECHNICAL DESCRIPTION
6.1 IDENTIFICATION
Support
stand.
Front support.
Mixing blades.
130L or 160L mixing drum.
Handle assembly.
Panel board.
Motor housing.
Switch ON/OFF.
Back support.
Wheels.
Drive gear shield.
Pivot bracket.
Safety pin.
230V Mains lead and plug (230V).
110V Mains lead and plug
(Stock No.01100 only
).
- 9 -
- 12 -
8. ASSEMBLY
FIG.5
FIG.6
FIG.7
FIG.8
4×
2×
Stock No.01099 (160L mixing drum) pictured.
Stock No.
01100 only
