DragonEye Compact Speed LIDAR Operator Manual
DragonEye Technology, LLC / Doc. 30666 Rev. 03
31
operator must press
. The unit will then prompt the operator
to perform a long range test. The long range test must be at least 10
metres or greater in integer meter value. Once that measurement is
completed and verified, the operator must press
. The front
of the LIDAR unit is the datum point; carefully obtain range readings
from the target. Verify the readings are /- 0.3 metres of the
actual range.
If the unit does not pass both of the above tests, carefully check your
setup and perform the test again. If the unit still does not pass,
please contact your specified service representative.
Alignment Test
The operator will be prompted to complete a horizontal and vertical
alignment test of the HUD aiming reticle by selecting a target with
straight boundaries such as a telephone pole or road sign at a
distance of 30 metres or greater. While holding the trigger in, slowly
pan the aim point on and off the target edge, verifying the range
reading in the HUD changes as the reticle passes onto the target. The
preceding verifies horizontal alignment. Rotate the unit 90° onto its
side while continuing to look through the HUD and repeat the above
test to verify vertical alignment. This will allow the operator to
confirm that the Infrared energy is contained within the aiming
reticule and the Lidar will confirm the range selected to perform this
test. The operator will again be prompted to press the
button.
The internal Self Test will also initiate automatically anytime the
LIDAR is turning on from an “off” state such as a change in batteries
or after the LIDAR is idle for a few hours.
MODE
ENTER
MODE
ENTER
MODE
ENTER
