10
DR
®
WIDE-CUT LAWN MOWER
Figure 2
Handlebar
Assembly
Handlebar Adjust
Lever
1
2
Specifications
Engine
See Engine Manufacturers Manual for detailed Engine information
Cutting Width
26" (SP26), 30" (SP30)
Cutting Height
8 Heights, 1" min to 4" max
Deck Material
Cast Aluminum
Wheel Size
8" x 2" Front, 10" x 3" Rear
Dimensions
67" L x 28" W x 42" H (SP26), 72" L x 32" W x 42" H (SP30)
Weight
30" E/S - 125lbs, 30" M/S - 117lbs, 26" E/S - 111lbs, 26" M/S - 101lbs
Parts Supplied in Shipping Box:
Mulching Plug (shipped inside mower housing)
Discharge Deflector
Bagger Assembly
Mower Assembly
Compare the contents of the Shipping Box with the “Parts Supplied” list above. If you have any questions please contact us at
www.DRpower.com or call 1-800-DR-OWNER (376-9637) for assistance.
Unfolding the Handlebars
1.
Move the Handlebar Adjust Lever to the left to release the Handlebar
(
Figure 2
).
2.
Hold the Lever as you pull up on the Handlebar Assembly.
3.
Release the Lever when you are near the desired position and continue
rotating the Handlebar until the pins lock into the holes in the side of the
Frame.
Adding Oil and Gasoline
Engine Oil
SAE 30: above 40 degrees F; 10w-30: 10-90 degrees F;
5w-30: 40 degrees F or below
Fuel
Unleaded gasoline
Note:
Refer to the Engine Manufacturers Manual for more detailed Engine information.
You must add oil before starting the engine. This machine is shipped without oil. Traces of oil may be in the reservoir
from factory testing, but
you must add oil before starting the engine.
Fill the reservoir slowly, checking the level
frequently to avoid overfilling.
To get an accurate reading when checking the oil level:
- The machine should be on a level surface.
- To ensure an accurate oil level reading, insert the Dipstick into the filler hole with Cap resting on top, but do not
screw it down.
