10
DR
®
1/2 TON VERSA TRAILER
6.
Insert the Dump Latch Pin through the Dump Bracket on the Tow Beam and
the Dump Bracket on the Bed and secure with a Hitch Clip (
Figure 8
).
7.
Insert an Axle into the Axle Bracket (
Figure 9
) with the Keyway on the end of
the Axle aligned with the Key Slot in the Axle Bracket. Repeat for the other
side.
8.
Install a M16 x 30mm Axle Bolt, Lock Washer and Flat Washer (
Figure 10
)
into the Axle End and tighten with a 24mm Socket or Adjustable Wrench.
Repeat for the other side.
9.
Back the Jam Nuts on the two M10 x 40mm Retaining Bolts (
Figure 11
) all
the way to the Head of the Bolts.
NOTE:
You will need to back all Jam Nuts up to the head of the Retaining Bolts
for all hardware shipped in the Hardware Kit prior to installation (
Figure 11
). Be
sure to tighten the Bolt first and then secure it by tightening the Jam Nut.
10.
Insert the two M10 x 40mm Retaining Bolts into the Axle Bracket Boss(es)
(
Figure 12
) and tighten the Bolt with a 16mm Socket. Tighten the Jam down
against the Boss using a 17mm Wrench.
Flat Washer Lock Washer
Axle Bolt
Figure 10
Figure 8
Dump Latch Pin
Hitch Clip
Jam Nut
Retaining Bolt
Figure 11
Figure 9
Keyway
Key Slot
Axle
Axle Bracket
Bosses
Bolt w/Jam Nut
Figure 12
