Attenuation Fine Adjustment (Continued)
Figure B
Figure C
7. After adjusting the clamps, tighten the screw to secure the clamp, making sure that the clamp
indent is making contact with a copper winding on the resistor. If the indent is not making contact with
the winding, the attenuator will not work (Figure D).
*Dr. Z Amplification is not responsible for any damage to your equipment by disassembling your
Brake Lite. It is the doctor’s opinion that these adjustments are subtle and stock values were picked
for a reason, so if you have any concern with your ability to follow these instructions then it’s best to
leave your equipment alone.
