CONTACT US AT
www.DRpower.com
9
7.
Raise the Boom by raising the Lift Arms on your Tractor. Position the Auger
onto the Output Shaft of the Gearbox (
Figure 10
).
8.
Align the bolt holes in the Auger with the bolt holes on the Output Shaft and
install the two 1/2"-13 X 3" Bolts, Lock Washers and Nuts. Tighten the
Hardware using a 3/4" Socket with extension through the Access Holes on
the Output Shaft Guard and a 3/4" Wrench.
9.
Position the PTO Shaft onto the Input Shaft of the Gearbox (
Figure 11
).
Align the Bolt Holes and install the 5/16"-18 X 3" Shear Bolt and Locknut.
Tighten the Hardware using a 1/2" Socket with extension through the Access
Hole on the Input Shaft Guard and a 1/2" Wrench.
10.
Install the 1/4-20 Set Screw into the threaded hole on the PTO Shaft using a
1/8" Allen Wrench. Screw the Set Screw all the way in then loosen it one full
turn.
11.
Attach the other end of the PTO Shaft to the tractor by pulling on the
Locking Collar and sliding onto the Tractor PTO.
12.
Attach the Manual Capsule to the Top of the Boom with three 5/16-18 X 1"
Bolts and Flat Washers (
Figure 12
). Tighten the hardware using a 1/2"
Wrench.
Adding Oil to the Gearbox
Tool and Supplies Needed:
•
S.A.E. 80W/90 or S.A.E. 85W/140 Multi-purpose Gear Oil
•
10mm Allen Wrench
•
6mm Allen Wrench
•
Clean Rags
Note:
Ensure that the Gearbox is Level when adding oil to ensure an accurate
reading.
1.
Remove the Oil Fill Plug from the top of the Gearbox using a 10mm Allen
Wrench (
Figure 13
).
2.
Remove the Overflow Plug from the side of the Gearbox using a 6mm Allen
Wrench
3.
Slowly add oil to the top of the Gearbox until it starts draining from the
overflow hole. Allow a few seconds for the oil to settle to get an accurate
reading.
4.
Reinstall the Overflow Plug into the side hole.
5.
Reinstall the Gearbox Plug into the top of the Gearbox.
Figure 13
Oil Fill
Plug
Overflow
Plug
Figure 12
Manual
Capsule
Bolts, and Flat
Washers
Boom
Figure 11
Shear
Bolt
Access Hole
Input Shaft
Guard
Gearbox
Input Shaft
Set
Screw
Auger
Access
Holes
Output
Shaft Guard
Figure 10
