10
5.0 Commissioning
5.1 SQUATINA Full blade guard attachment
5.1.1 Saw blade change
Remove the hex screw of the saw flange by turning it
clockwise. Attention, the screw has a left-hand thread.
Remove the top half of the flange with the matching
washer.
Insert the blade into the guard and plug it onto the output
spindle fitting. Always thoroughly grease the saw blade
hole and the output spindle as well as the hex screw.
Place the top half of the flange with the
matching washer onto the saw blade and
make sure that the flange half engages the output
spindle. Attach the hex screw and tighten by turning
anticlockwise. To tighten the hex screw with a SW17
spanner, you must hold the output spindle at the same
time with an SW27 spanner.
5.2 SQUATINA Flush cut blade guard attachment
5.2.1 Saw blade change
Proceed as described above in 5.1.1, but loosen or tighten the 6 hex socket countersunk head screws
instead of the centred left hand thread screw.
