Miernik sygnału satelitarnego
6
7. Use the gain adjustment knob
to set the indicator on the display
to position 5. Change the
antenna position until the indicator on the display
shows the maximum value and an audible
signal sounds. If necessary, repeat these activities several times.
8. After setting the appropriate position, mount the antenna according to the assembly instructions
provided by the antenna manufacturer.
9. Disconnect the tuner from the power supply.
10. Disconnect the meter from the tuner and LNB.
11. Connect the antenna to the tuner and check that it works correctly. If the quality of the received
signal is too low, repeat the configuration procedure described in p. 1-10.
Checking the polarity
SATFINDER has an LED indicator showing the polarization selected by the tuner
. To set the antenna
in both polarizations, during the configuration, switch the polarization options in the tuner settings.
Checking the 22 KHz signal
SATFINDER has an LED indicator for sending a 22 kHz
signal through the tuner, used to switch
the LNB converter from the lower band signal to the upper band.
To avoid interference, do not stand with the meter facing the satellite dish when
setting its position
When using a gain converter > 60 dB, a 5 dB attenuator should
be connected between the converter and the meter during configuration.
Warranty
The warranty terms are available at http://www.dpm.eu/gwarancja
Summary of Contents for SATFINDER
Page 15: ......
