The connection should be installed
according to the procedures shown
in the pictures shown right.
Liquid Temperature
0ºC–110ºC
Ambient Temperature
Max 55ºC
Operation condition
Installation
The pump is lubricated and cooled by the liquid being pumped.
It will cause severe damage when the pump runs dry for over
10 seconds.
After installation, the piping system must be vented.
Follow the arrow on the pump flange for direction of water flow,
it may be installed in vertical or horizontal piping, but be sure
the motor shaft must be always in horizontal position.
Plug in the power cord.
Turn the switch to any
speed.
Open the tab.
Screw off the vent screw,
until water come out.
Liquid Temperature
Ambient Temperature
0 C~110 C
Max. 55 C
1
2
3
The connection should be installed according to the procedures
as shown in Picture below.
1
2
3
4
Release the vent screw until
the water comes out
Open the tap
