A 18
Step #3
Suggested values
SP3 appears.
Use the arrows to adjust to the desired temperature
(375°F)
Press on the number of the menu to confirm
(ex. # 2)
t3 appears
Use the arrows to select the desired timing
(00:15)
Press on the number of the menu to confirm
(ex. # 2)
E3 appears
Use the arrows to select the desired code
(0010 for the buzzer)
Press on the number of the menu to confirm
(ex. # 2)
To get out of the programming mode, press #12 and then press "CLOCK" twice (#12, CLOCK,
CLOCK). The screen will show 00:00.
After fulfillment of this program:
•
The oven will continue to heat because there was a temperature included in step 3. If the
temperature at that step would have been of 0
°
F, the oven would have stopped at the end
of the program.
•
In this example, the inside buzzer will work 15 seconds while the outside buzzer will start
and will not stop until another program is selected.
•
If you want to end a program already running, press the button corresponding to that menu
and then choose a pause menu. If you stop a program that was running without choosing
another menu, it will be paused in the conditions in which it was stopped. Ex: If there is
an interruption during a steam cycle, it will keep running until you choose another menu.
However, there is a 45 seconds limit time for the steam, independent from the Watlow
controller.
Summary of Contents for JAOP3
