D
OVRE
4
Subject to change because of technical improvements
Declaration of
conformity
Notified body: 0359
The undersigned
Dovre NV, Nijverheidsstraat 18 B-2381 Weelde,
hereby declares that the VIRTUS 50GA (P) / 70GA(P)
gas stove has been produced in accordance with EN
613.
Weelde 01-03-2019
Due to continuous product improvement, the spe-
cifications of the appliance supplied can vary from the
description in this brochure without prior notice.
DOVRE N.V.
Nijverheidsstraat 18 Tel : +32 (0) 14 65 91 91
B-2381 Weelde
Fax : +32 (0) 14 65 90 09
Belgium
E-mail : [email protected]
Safety
Please note: All safety regulations must be
complied with strictly.
Please read carefully the instructions supplied
with the appliance for installation, use and
maintenance before using the appliance.
The appliance must be installed in accordance
with the legislation and requirements applic-
able in your country.
All local regulations and the regulations relating
to national and European standards must be
observed when installing the appliance.
The appliance must be placed, connected,
commissioned and inspected by an authorized
installer, in accordance with the current
national and local standards, in accordance
with regulations for closed appliances and in
accordance with the installation instructions of
the manufacturer.
The appliance is designed for heating pur-
poses. All surfaces, including the glass and the
connecting pipe, can become very hot (more
than 100°C)! This must be regarded as an act-
ive zone. Make sure there is sufficient pro-
tection if young children, disabled persons or
old people are in the vicinity of the appliance.
Safety distances from flammable materials
must be strictly adhered to.
Do not place any curtains, clothes, laundry or
other combustible materials on or near the appli-
ance. The minimum safe distance is 80 cm.
When in use, do not use flammable or explos-
ive substances in the vicinity of the appliance.
If the glass in the appliance is broken or
cracked, it must be replaced before you can
use the appliance again.
The appliance has been set and sealed in the
factory, in accordance with the category stated
on the model plate and at the correct nominal
load. Check that the information on the model
plate corresponds with the local gas type and
pressure, and with the nature of your install-
ation.
