2530GA(P)
- 39 -
03.27603.000
Manual Mode (MAN in display) for Manual Flame Height Adjustment
•
Press
p
to turn on the fire (main burner) or to increase flame height.
•
Press
q
to decrease flame or to turn down to pilot.
•
To incrementally increase or decrease the flame height lightly tap either
p
or
q
The “send“ symbol appears in the upper left corner of the display when either button
is depressed. The LED of the receiver flashes when knob B of the valve reaches its
end stops.
Automatic Mode (AUTO in display) for Temperature Control
•
Briefly press
AUTO
. The set temperature will appear briefly before the display
reverts to the room temperature.
Timer Mode (TIMER in display)
During heating periods
P1
ã
and
P2
ã
, the temperature is controlled in the same
manner as in automatic mode.
When the timer program turns to
»
(heating cycle off), the motor will turn the valve
to pilot and there is no temperature control. This minimizes battery consumption.
•
You may press
AUTO
to verify the set-temperature and then press
TIMER
to re-
turn to timer mode.
•
You may press either the
p
or
q
button from any mode for manual override.
•
To prolong battery life, we recommend switching the transmitter to manual
mode and turning the fire to pilot with the
q
button before turning the appli-
ance off. If the transmitter is left in automatic or timer mode, the batteries will
continue to be used when the appliance is off.
Changing the Battery
•
If
BATT
appears on the display or if the LED of the receiver becomes faint, please
change the battery from transmitter or receiver. If the batteries lose power, the
flame height can be adjusted by manually turning knob B (see above).
Remarks
•
Please note, the placement of the transmitter (temperature sensor) is important
to assure proper temperature regulation. Generally, a more constant tempera-
ture will be assured, if the transmitter is not too far from the gas appliance.
However, never use the transmitter in very close proximity to the receiver (less
than 1m / 3ft).
•
Before switching to
AUTO
or
TIMER
mode, press either button (
p
) or (
q
) to ver-
ify the reception (when the send symbol appears in the transmitter display, the
receiver’s LED must illuminate). For the
AUTO
or
TIMER
mode to function cor-
rectly, the transmitter must remain within range of the receiver.
•
The temperature is controlled by activating the motor for a specific length of
time to adjust the appropriate flame height. This time is calculated by the trans-
mitter and depends on variables such as room size, heater capacity, battery
power, etc. Therefore, a few cycles are necessary be fore an optimum is achieved.
•
If a low flame is sufficient to provide enough warmth to the room, then the appli-
ance will cycle between low fire and off. This allows longer periods with the
flame on and provides a more uniform room temperature.
•
In very rare cases, the motor can get blocked when the knob B on the gas con-
trols reaches the end points of its turning radius. The knob must then be turned
manually to free the blockage.
Summary of Contents for 2530GA
Page 58: ...2530GA P 58 03 27603 000...
Page 59: ...2530GA P 59 03 27603 000...
