15
K. GEAR END ASSEMBLY
1. Bolt gear-housing (60) loosely into both
frames (64, 65).
2. When reassembling, apply grease to parts
such as thrust washers, o-rings, and seals.
Install the output shaft (38) into the gear
housing (60). Slide the thrust washer (37)
onto the output shaft (38). Next, install the
output gear set (40). Then install the
retaining ring (47) onto the output shaft (38).
Push the gear set and shaft back into the
housing until it stops against the thrust
washer (37).
(Note: Make sure to line up all
three planet gears in the output gear set with
the gear housing as it starts into the
housing).
3. Install the sun gear (46) and spacer (28).
4. Install the adapter (22) onto the gear
housing (60). Making sure not to damage
the o-ring (59), use eight capscrews (32)
and torque them to specification (see page
25 of this manual).
5. Install the gear ring (22), using two
capscrews (111), onto the adapter (58)
making sure not to damage the o-ring (57).
Next, install the secondary gear set. (
Note:
Make sure to line up all three planet gears in
secondary gear set with the gear housing
and sun gear as it starts into the housing.
)
6. Install the secondary sun gear (45).
7. Install the inner thrust washer (43) onto the
input gear set (42). Insert the input gear set
(42) into the gear housing (60) making sure
it is against the thrust washer (43). Put the
outer thrust washer (43) in place and slide
the input shaft (39) through the sun gears
and output shaft (38). Let the input shaft
protrude out on the gear end so that all of
the spline is showing.
8. Install the input sun gear (44) onto the end
of the input shaft (39). Install the retaining
ring (114) onto the input shaft (39). Push
back on the input shaft and sun gear at the
same time until the sun gear engages the
three planet gears on the input gear set.
Check and verify that the bearing (23) is
pressed into the cover (55), then put the
cover on and secure it with the ten cap
screws (112), being careful not to damage
the o-ring (57)
.
Summary of Contents for TWG Tulsa RN80 PHLXOA1
Page 24: ...24 VISCOSITY CHART...
