Douglas Dynamics Western Striker 98805, Owner'S Manual

Page: 24 / 36

Lit. No. 74125/74126, Rev. 00 24 July 1, 2020
OPERATING THE SPREADER
ACCESSORY LED WORK LIGHT
The accessory work light can be purchased through
your authorized dealer. Follow the work light
Installation Instructions to wire the accessory work
light to the button on the electrical box.
A second LED light and harness can be also be
added. Accessory work light kits are available through
your authorized dealer.
DUMP FUNCTION
The dump function allows the operator to activate the
material feed to empty the hopper after use or load
material into a walk-behind spreader.
The dump function is a two-handed operation requiring
the operator to press two buttons at the same time.
The material feed buttons are located on driver's
side of the electrical enclosure at the hopper rear.
The spinner motor harness must be disconnected to
enable the dump function.
1. Disconnect the spinner motor harness.
2. Remove the
bottom
cotter pin and locking pin from
the spinner drive assembly and chute supports.
3. Rotate the spinner drive assembly upward, and
secure it raised position by reinserting the locking
pin through the
top
hole in the chute supports and
spinner drive assembly.
Material Feed
Buttons
Driver’s Side Curb Side
4. Insert the cotter pin into the locking pin.
5. Position the material receptacle or walk-behind
spreader under the end of the conveyor.
6. Press and hold both material feed buttons to
operate the conveyor.
NOTE: Do not stand directly in front of the auger
when operating the dump function.
7. To stop the conveyor, release one or both of the
material feed buttons.
Lock
Pins
Spinner
Drive
Assembly