Safety instructions
In order to protect the exposed connection cable when there is a risk of animal damage, it should
be equipped with a Marten protection (mounting accessories) are provided. Luminaires / power
supplies with defective cables must not be operated any further.
High ambient temperatures shorten the service life of the LEDs. To get a long lifetime of the LED,
good heat dissipation must be ensured. Therefore, do not expose the LED spotlight to ambient tem-
peratures> 50 ° C during operation. Do not cover the LED spotlight, ensure that air can circulate
freely.
Installation
Unpack the entire scope of delivery and check the contents for completeness and Integrity. Dispose
of packaging material that is no longer required in accordance with the applicable regulations.
First attach the mounting bracket of the light to the ground spike with an M6 screw and a locking
ring. The mounting bracket can also be attached directly to suitable surfaces without a ground
spike.
Then the LED spotlight can be screwed into the bracket, the plastic washers are placed between
the lamp and bracket, then the bracket is screwed on the left and right with two M6 screws and a
locking ring. Align the lamp accordingly before tightening the screws.
Plug the connection cable of the spot into the corresponding socket of the power supply unit. If
further extension sets are connected, use the corresponding cable distributor and, if necessary, the
extension cable available as a special accessory. Make sure that the union nuts of the connectors
are firmly tightened, this is the only way to guarantee protection against moisture. The connector
system is reverse polarity protected. We recommend burying the connection cables to protect them
from being bitten by animals or laying them in a conduit. The power supply unit should be placed
in a location that is as protected from the weather as possible. Avoid constant moisture and direct
sunlight. Make sure that the power supply unit cannot be flooded, even in heavy rain. The power
supply unit must not be buried. If necessary, use a housing to protect the power supply unit from
the elements.
Maintenance, care
Clean the LED spotlight from time to time with a damp cloth. Do not cover the spots, remove any
leaves covering the LED spot and ensure that heat can dissipate freely from the housing.
dot-spot
mini LED garden spotlights 3W
are built without potting, so they can be dismantled and repaired.
This is also an important contribution to environmental protection. Even after the warranty period
has expired, the LED spotlight can be repaired in the event of a fault or damage dot-spot offers
attractive flat-rate repair fees.
Disposal
When the end of use is reached, dispose of the spotlight and all accessories in accordance with
the applicable environmental regulations. Electrical waste must not be disposed of together with
household waste. The
dot-spot mini LED garden spotlights 3W
can be dismantled into individual
parts after use and thus optimally recycled.
10
en
