B-1
APPE NDIX
B
Using a Standalone JBOD Array (SANnet II
200 FC Array Only)
A single SANnet II 200 FC JBOD array can be connected directly to certain Solaris
operating system hosts. This appendix describes the use of SANnet II 200 FC JBOD
arrays.
Note –
SANnet II 200 SATA and SATA SE configurations do not support the use of
JBOD arrays.
The topics covered in this appendix are:
■
“Supported Configurations (JBOD Arrays)” on page B-1
■
“Supported Operating Systems (JBOD Arrays)” on page B-2
■
“Supported Host Platforms and Connection Methods (JBOD Arrays)” on page B-2
■
“Known Limitations Affecting SANnet II 200 FC JBOD Arrays” on page B-2
■
“Using SANnet II Family Software Monitoring and Management Tools with JBOD
Arrays” on page B-3
■
“Setting the Loop ID on a SANnet II 200 FC JBOD Array” on page B-4
■
“Connecting SANnet II 200 FC JBOD Arrays” on page B-6
■
“Enabling SANnet II 200 FC JBOD Array Support” on page B-10
■
“Downloading Firmware to Disk Drives in a JBOD” on page B-11
■
“Resizing LUNs Greater Than 1 Tbyte” on page B-12
■
“Troubleshooting SANnet II 200 FC JBOD Arrays” on page B-12
■
“Converting a JBOD to a RAID array” on page B-16
B.1
Supported Configurations (JBOD Arrays)
A SANnet II 200 FC JBOD array can be attached directly to a single host computer
using either single-port or dual-port configurations. See “Single-Port Connection to a
SANnet II 200 FC JBOD Array” on page B-6 and “Dual-Port Connections to a
SANnet II 200 FC JBOD Array” on page B-7 for more information.
