Dorsch Mikrosystem VME-PROF-S, Technical Manual

Page: 14 / 51

VME-PROF-S Technical Manual
DMS Dorsch Mikrosystem GmbH - 24972 Steinbergkirche Tel. (+49)4632/1411
942.1316.54 13
1.4. Order Codes
VME-PROF-S VMEbus 68331 CPU, PROFIBUS DP-Slave 12 Mbit/sec, RS232, 6HE
VME-PROFS3 VMEbus 68331 CPU, PROFIBUS DP-Slave 12 Mbit/sec, RS232, 3HE
Other PROFIBUS products:
IPE VMEbus with 68040 CPU, 64 MHz, 8 MB RAM, IEC-1491 and PROFIBUS
DP-Master interface 3 Mbit/sec, RS232, 20 mA, 2 Memorycards
PCI-40 PC ISA-Slotcard with 68040 CPU, 64 MHz, 8 MB RAM, IEC-1491 and
PROFIBUS DP-Master interface 3 Mbit/sec
PCP-DP PC ISA-Slotcard with PROFIBUS DP-Master interface 3 Mbit/sec
VME-PROFI VMEbus PROFIBUS Interface 6 HE, 3 Mbit/s incl. PROFIBUS-DP-Master
Software
VME-PROFI3 VMEbus PROFIBUS- Interface 3 HE, 500 kbit/s incl. PROFIBUS DP-Master
Software
PMC-PROFI PMC Mezzanine Module with PROFIBUS DP-Master interface, 3 Mbit/s incl.
PROFIBUS-DP-Master Software
PCU PROFIBUS Control Unit with graphic display 320*240 pixel, 68331 CPU, 512
kB RAM, 2 MB Flash, Ethernet-Controller, OS9-Extended, TCP/IP, DP-
Master Firmware
PST PROFIBUS DP Slave Terminal, display with 2 lines a 24 characters
Accessories:
PROFI-STV PROFIBUS Bus connector (9 pol. DSUB) with switchable terminating
resistors
PROF-KABEL PROFIBUS cable
1.5. Safety precautions
Caution
•
The device may only be used in subracks that meet the requirements of the following
VMEbus standards: ANSI/IEEE STD1014-1987, IEC 821 and 297 [2]
•
The device may only be switched on if installed properly.
•
The device must be disconnected from the VCC power supply prior to connecting or
disconnecting hardware interfaces.
•
Handle with care! The device must be protected from electrostatic discharge (see
EN 100015-1).
•
This device uses, produces and may emit high-frequency signals. Operation of the
device may be disturbed by strong high-frequency signals. The device has been
designed by DMS for a high degree of electromagnetic compatibility, e.g. galvanic
separated front interfaces, multi-layer technology, etc. have been incorporated in the
design. Please make sure that the device is used in compliance with all applicable
regulations regarding electromagnetic compatibility (EMC). See „Declaration of
Conformity“ in the Preface chapter.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com