DÖRR EcoGun AS AUTO pro, Operation Manual, Page: 9 / 44

Fig. 2: Assembly
2. Push spray gun with the fastening bore
(1) on the support bracket.
Alignment is arbitrary. The dis-
tance to the work piece must be
15 to 25cm.
3.
WARNING!
Statically charges components may
cause explosions during operation!
Ground the spray gun through the fas-
tening bore or material connection lines, if
the support bracket itself is non-conduc-
tive or is not grounded. Ensure housing
contact.
Resistance between housing and
grounding terminal ≤ 1M Ω .
Fig. 3: Connect
4.
The spray gun does not work
when the lines are not connected
correctly.
Connect lines. Ensure correct assign-
ment.
1 - Material (M)
2 - Spraying air (A)
3 - Control air (C)
Connect lines to both material con-
nections for paint circulation mode.
For tap line mode, connect line to a
material connection. Close the other
material connection with the locking
screw ( Ä 12.3 “Accessories”) sup-
plied as accessory.
Assembly
02/2020 EcoGun AS AUTO pro - MSG00005EN 9/44