DÖRR EcoGun 249, Operation Manual

Page: 4 / 40

1 Product overview
1.1 Overview
Fig. 1: Overview
1 Air cap
2 Cap nut
3 Material connection
4 Flat jet control
5 Locknut
6 Material flow control
7 Air connection
8 Air control
9 Trigger
1.2 Short description
The spray gun is intended for surface
coating. Compressed air is used to apply
material. The coating material is fed through
lines. The spray gun is handheld.
Gun versions with LP air caps, LC air
caps, LG air caps and LE air caps and
non-adjustable nozzle needles are sup-
plied with a needle packing for materials
that have a low proportion of abrasive
ingredients. These gun versions are here-
after called standard version.
Gun versions with LS air caps and LE air
caps and adjustable nozzle needles are
supplied with a needle packing for mate-
rials that have a high proportion of abra-
sive ingredients (for example enamel,
glaze). These gun versions are hereafter
called ceramic version.
Use a suitable nozzle set with air cap,
depending on the requirement. Ä 6.3
“Selecting air cap”.
The following factors influence the spray jet
and the result:
Alignment of the air cap Ä 6.5 “Alignment
of the air cap”
Material flow
Ä 5 “Commissioning”
Air pressure Ä 5 “Commissioning”
Horn air pressure Ä 5 “Commissioning”
The standard version of the spray gun uses
a self-adjusting needle packing. The needle
gland automatically regulates the material-
related wear of the needle gland seal. In
addition, the needle packing can be read-
justed mechanically.
2 Safety
2.1 Explanation of symbols
The following notes can appear in this
instructions manual.
DANGER!
High risk situation that can lead to serious
injuries or death.
WARNING!
Medium risk situation that can lead to
serious injuries or death.
Product overview
12/2016 EcoGun 249 - MSG00014EN 4/40