Operating Manual
© Dürr Systems AG
82 / 156
EcoBell2 SL EC - Rotating Atomizer with External Charging
Cleaning and maintenance
Document No.: MRA00001EN
Version:: 07
•
As of:: 01/2020
A T T E N T I O N
Risk of damage to property and production disruption
Cleaning agent must not leak into the atomizer while cleaning the bell
disk.
Shaping air and motor bearing air must be switched on if the bell disk
is cleaned on the atomizer.
Cleaning agent and impurities may enter the atomizer in the absence
of shaping and motor bearing air.
A T T E N T I O N
Material damage due to unsuitable cleaning agent
The aluminum bell disk is not resistant to water-based cleaning
agents.
Do not immerse the aluminum bell disk in water-based cleaning
agents for extended periods of time.
A T T E N T I O N
Risk of damage to property and production disruption
The surface of the atomizer body and that of the electrode ring can
get scratched and can thus be soiled more.
Do not use abrasive cleaning accessories.
7.1.2
Servicing and maintenance
The manufacturer does not permit repairs of individual components of
the product. You may only replace damaged components. The
suitable spare parts are available in the chapter “Spare parts."
A T T E N T I O N
Replacement parts that are not approved by Dürr Systems may
not be able to withstand the loads.
It can result in property damage and production disruption.
Use only original spare parts.
The spray system must be in the "Maintenance" mode before entering
the spray carbine. Make sure that no one can switch on the station
while someone is present in the spray booth.
In case of queries regarding servicing and maintenance work or if you
require support in training personnel, contact our training department
(see chapter “Contact & Hotline”).
