doerr-outdoor.de
12
06 |
FIRST COMMISSIONING
06.1 Inserting the batteries into the receiver
Slide down the battery compartment cover (10) to open it. Insert
3 pcs
AAA LR03 batteries
(not included)
according to the polarity mar-
kings +/-
in the battery compartment. Close the battery compartment
cover.
06.2 Inserting the batteries into the motion detectors
Unscrew the screw (17) of the battery compartment cover and remove
the battery compartment cover (18). Insert
3 pcs AAA LR03 batteries
(not included)
according to the polarity ma/-
in the batte-
ry compartment. Close the battery compartment and screw on the
screw again.
07 |
OPERATION
07.1 Turning On/Off
07.1.1 Receiver:
To turn on the receiver, switch the On/Off switch (08) to position ON.
The LED power indicator (06) flashes red. To turn the receiver off,
switch the On/Off switch (08) to position OFF.
07.1.2 Motion detectors:
To turn the motion detectors on, press the On/Off button (15). The
On/Off button flashes green for about 2 seconds. Then the green LED
will shut down to save battery power — but the motion detector is still
on and ready for operation. To turn the motion detectors off, press the
On/Off button (15) for about 3 seconds.
07.2 Connecting the receiver with the motion detectors
1.
Set the On/Off switch of the receiver (08) to the ON position. The
LED power indicator (06) flashes red and indicates readiness for
signal reception.
2.
Press the On/Off button (15) of the motion detectors.
3.
The motion detectors now connect automatically with the recei-
ver. While connecting the corresponding LED signal indicator (02)
flashes green with sound and vibration. After successful connec-
tion the LED signal indicators (02) will light green constantly.
LED indication kit with 2 motion detectors
(Item-No.
204804
)
LED No. 1 lights green constantly
Motion detector 1 is active
LED No. 2 lights green constantly
Motion detector 2 is active
LED indication with further motion detectors FB-300S
(Item-No.
204805-A,-B,-C
optional
)
LED No. 3 lights green constantly
Motion detector 3 is active
LED No. 4 lights green constantly
Motion detector 4 is active
LED No. 5 lights green constantly
Motion detector 5 is active
NOTE
•
The distance for connection is approx. 300 m in an open envi-
ronment.
•
If distance between receiver and the motions detectors is quite
far, please pull out the receiver antenna (01) to enhance the
signal.
> How to connect additional senders, refer to chapter 10.
07.3 Alarm signal
When a motion detector registered a movement, the corresponding
LED indicator flashes green.
For example:
Motion detector 2 registers a movement = LED 2 at the signal indicator
(02) flashes and the receiver will send out a 15-second sound and vib-
ration alarm.
07.4 Adjusting the volume/Earphones
The volume of sound alarm can be regulated or turned off completely
by turning the volume controller (05) on the top of receiver. Optio-
nally you can use earphones. In this case connect the earphones (not
included) to the earphones socket (04).
CAUTION:
A too loud volume can damage your hearing when using ear-
phones!
07.5 Vibration alarm
The vibration alarm is always active and
cannot
be regulated.
