Doro wt89, Manual

Page: 24 / 44

24 www.doro.com
English
Voice control (VOX)
This unit can be used without having to press the
PTT
button to transmit. By
setting the correct level, the PMR unit can determine whether or not you are
speaking. Test different settings until the sensitivity selected is acceptable. Please
note that however accurate your setting there ia always a small risk that increased
noise from the surroundings may activate the transmitter, this may result in the
initial word being unclear. If the PMR unit transmits by itself the sensitivity may
be set too high and will need to be adjusted.
The transmitter will shut off two seconds after you have finished speaking, the
display will show
VOX
when the function is active.
1.
Press
w
repeatedly until
VOX
is displayed.
2.
Scroll the required sensitivity using
v
/
V
(OF=off, 1=insensitive....3=most sensitive).
3. Press PTT to confirm.
Scanning
You can scan all available channels to locate any signal being transmitted. Once a
signal has been located press PTT to stop scanning. While searching battery power
consumption will be significantly higher than normal.
1.
Press
w
and
v
at the same time. The unit will start scanning.
2. To stop scanning press PTT .
Call melody
You can select different call melodies.
1.
Press
w
repeatedly until
CA
is displayed.
2. Select the desired setting using
v
/
V
(OF=off).
3. Press PTT to confirm.
Termination tone (Roger tone)
You can activate a tone which is heard when you release the
PTT
button. This can
be used as a reminder to the other person that you have finished talking and are
waiting for a response.
1. Press
w
repeatedly until ro is displayed.
2. Select the required setting (
v
=on,
V
=off).
3.
Press
PTT
to confirm.
Key tone
This tone is heard when you press any button on the PMR.
1. Press
w
repeatedly until to is displayed.
2.
Select the required setting (
v
=on,
V
=off).
3.
Press
PTT
to confirm.
Searching two channels (Dual Watch)
You can enter a different channel for simultaneous listening while using your original
main channel.
1.
Press
w
repeatedly until
DW
is displayed.
2.
Select the required using
v
/
V
(OF=off).
3. Press PTT to confirm.