Doro PhoneEasy DECT 315, Manual

Page: 4 / 48

English
Turning the Handset Off/On
The handset can be turned off by pressing
1
for a few seconds.
The handset can be switched on by pressing
1
once.
Paging
The handset will ring when
J
(on the base unit) is pressed. The
signal will stop automatically after a while or if the
q
button on the
handset is pressed, or by pressing
J
on the base unit.
Expanded system (only +1…)
The handset number used for internal calls is shown on a label on each
handset.
The base unit should be positioned centrally so that the coverage area
is roughly equal for all handsets.
It is not possible to add extra handsets at a later point.
INT calls
1. Press
I
.
2. Enter the allocated number of the handset that you wish to call,
1
-
5
.
A tone will be heard if an external call comes in while an internal call
is in progress. You can terminate the internal call by pressing
q
, and
then receive the external call by pressing
q
again.
Transferring calls/Conference between handsets
1. An external call is connected.
2.
Initiate an internal call as described above.
3. Press
q
to transfer the call, or hold down
R
for conference.
Dialling Method (not normally used)
Tone/pulse can be selected by pressing
R
followed by
*
.
- two beeps=normal/tone dial
- four beeps=pulse dial
Specific Absorption Rate (SAR)
This device meets approved international safety requirements
for exposure to radio waves. This telephone measures 0.06 W/kg
(measured over 10g tissue).
The max. limit according to WHO is 2W/kg (measured over 10g tissue).