Doro congress Programmer, Manual

Page: 4 / 36

EN 1
English
Connection
1. Locate the battery cover on the underside of the base, using a pen or similar, carefully
push the retaining catch forward and lift the cover off. Install 4 x AA good quality alkaline
batteries ensuring correct battery polarity is observed and refit the battery cover.
When the batteries are running low will be displayed.
2. Connect the supplied cord to the socket marked UP LOAD .
3.
Turn the unit
ON
using the
POWER ON/OFF
switch located on the side of the unit.
4. Press SETUP . Select a language using
v
/
V
, to confirm press STORE . Adjust the
displays contrast using
v
/
V
, to confirm press STORE .
Memory
The programmer can store up to 30 One-Touch Memories (only 10 memory positions
are required for the Doro Congress 150).
Memory programming
1. Press PROGRAM (the button will illuminate).
2. The display will show MEMORY #01 .
3.
Enter the required number using the keypad. To move the cursor press
v
/
V
, to
erase press
DELETE
.
4. To confirm press STORE .
5. SAVE! will be displayed. The next memory position can now be programmed.
6. Press PROGRAM to exit memory programming.
Changing a memory
1. Press
v
/
V
to select the required memory location.
2. Press EDIT .
3. EDIT?
will be displayed.
4. Press STORE to confirm.
5. Move the cursor using
v
/
V
. To erase press DELETE , or enter a new number using 0-9.
6. Press STORE to save any changes.
7. SAVE!
will be displayed.
8. Press PROGRAM to exit.