Doro COMFORT 1005, Manual

Page: 14 / 20

English
Note!
A pre-recorded message is used until you make your own recording, and that
message can also be restored if required. To restore this, press
C
during playback
of outgoing message.
Personal message (MEMO)
1. Press . Select ANS. MACHINE . Press OK .
2. Select
MEMO
. Press
OK
.
3. After the long beep you can record your message (speak 20 cm from the
handset).
4. Press OK . The message will be played back to you.
5. Memos are played back in the same way as ordinary incoming messages.
Screening
Incoming messages will be heard on the loudspeaker of the base unit as they
are received. If nothing can be heard, check that the volume is turned up and
that the function has been activated, see Setup from handset, p. 7 . You can
also press
OK
on the handset while recording is in progress. The call can be
intercepted by pressing
q
or lifting the receiver of another phone connected
to the same line.
Out of memory
The memory has room for up to 59 messages (including the outgoing message)
max. 15 minutes depending on the compression you set. When TAM FULL is
displayed or the base unit flashes FF , no new messages can be recorded until
the old ones have been played back and deleted. In that case, the answering
machine responds with the outgoing message for Answer Only.
Note!
Remember to delete messages regularly!
Remote access
The answering machine can be remotely accessed using an ordinary tone dial
phone.
1. Call the answering machine (the number that your answering machine is
connected to, usually your home number).
2. Press
*
when the outgoing message is played.
3. Enter PIN code (default code is 0000), see Setup from handset, p. 7 .
4. Select remote access command(s):
10