Dorner AquaPruf 76P1 Series, Installation, Maintenance, And Parts Manual

Page: 22 / 52

Dorner Mfg. Corp. 22 851-946 Rev. A
AquaPruf® Positive Drive Conveyors
Preventive Maintenance and Adjustment
8. Slide the headplate with bearing (Figure 57, item 1) off
the shaft. Replace bearing if worn. Refer to “Bearing
Replacement” on page 25.
Figure 57
Figure 57
9. Remove guard puck (Figure 57, item 2) from end of
drive spindle.
10. Slide entire sprocket assembly slightly outward, and
remove the first sprocket (Figure 58, item 1) off the
drive spindle and alignment key (Figure 58, item 2) .
Figure 58
Figure 58
11. Remove remaining sprockets (Figure 59, item 1) off
the alignment key (Figure 59, item 2) while sliding the
entire assembly off the drive spindle
(Figure 59, item 3) .
Figure 59
Figure 59
12. Replace components, as needed (Figure 60) .
Figure 60
Figure 60
13. Install parts in reverse order of removal.
Motorized Pulley Drive Tail
1. Remove limiter. Refer to “Limiter Replacement” on
page 15.
2. Remove conveyor belt. Refer to “Conveyor Belt
Replacement” on page 15.
3. Lift each locking plate (Figure 61, item 1) on each side,
as shown, on drive end (Figure 61, item 2) .
Figure 61
Figure 61
2
1
1
2
3
1
2
NOTE
To reassemble please note the placement of the
sprockets on the alignment key.
1
1
2