DORNA TECHNOLOGY H300 Series, User Manual

Page: 50 / 106

-47-
13 Frequency limited
If the set frequency exceeds the frequency upper
limit or lower limit and the output frequency of the
inverter reaches the upper limit or lower limit, the
terminal becomes ON.
14 Torque limited
In speed control mode, if the output torque reaches
the torque limit, the inverter enters stall protection
state and meanwhile the terminal becomes ON.
15 Ready for RUN
If the inverter main circuit and control circuit power
becomes stable, and the inverter detects no fault and
is ready for RUN, the terminal becomes ON.
16 AI1 larger than AI2
When the input of AI1 is larger than the input of
AI2, the terminal becomes ON.
17
Frequency upper limit
reached
If the running frequency reaches the upper limit, the
terminal becomes ON.
18
Frequency lower limit
reached (no output at stop)
If the running frequency reaches the lower limit, the
terminal becomes ON. In the stop state, the terminal
becomes OFF.
19 Under voltage state output
If the inverter is in under voltage state, the terminal
becomes ON.
20
Communication
setting
Refer to the communication protocol.
21 Reserved Reserved.
22 Reserved Reserved.
23
Zero-speed running 2
(having output at stop)
If the output frequency of the inverter is 0, the
terminal becomes ON. In the state of stop, the
signal is still ON.
24
Accumulative power-on time
reached
If the inverter accumulative power-on time (P7.13)
exceeds the value set in P8.16, the terminal
becomes ON.
25
Frequency level detection
FDT2 output
Refer to the descriptions of P8.28 and P8.29.
26 Frequency 1 reached Refer to the descriptions of P8.30 and P8.31.
27 Frequency 2 reached Refer to the descriptions of P8.32 and P8.33.
28 Current 1 reached Refer to the descriptions of P8.38 and P8.39.
29 Current 2 reached Refer to the descriptions of P8.40 and P8.41.
30 Timing reached
If the timing function (P8.42) is valid, the terminal
becomes ON after the current running time of the
inverter reaches the set time.