Confidant RFID Exit Device Operators
PK3664-T
04-17
9
10- Install lock on door
(Bluetooth and/or
Messenger Version)
H1
H2
W
I
G
H3
S-BASE
S-COVER
A
B
C
D
F
S1
S-SCREW
E
W1
A Pass wires (W) through the hole (H1). For the hollow doors, the wires shall pass inside the door to come
out from the hole (H2).
B Place the outside housing (I) on the door.
C Attach adaptor plate (G) to the lock (I) using 2 flat head screw (D) (12-24unc) (for solid doors, make sur
that the wires are in the groove (S1).
D Attach the Exit Device chassis (F) to the Adaptor Plate (G) using 2 screws or 4 screws (B) depending on
the Exit Device. For Detex only, use 2 or 4 Flat washers (C).
E Make sure the lock and the Exit Device are well aligned and then tighten screws.
F Connect wires (W) to (W1) and put the excess cables and connectors in the hole (H2) on the door.
G Attach the base (S-base) to the adpator plate (G) with the two screws. Put the cover (S-cover) as shown,
and put the screw (S-screw).
H Follow the manufacturer’s instructions to complete the installation of the exit device and the appropriate
strike
