WATCHMAN Installation Instructions
Page 4 For Assistance: [email protected] (909) 591-8431 PID1244R6-6
Installation Instructions
1) Using a 5/32" hex wrench, secure the Main End cap onto the Left End tube.
2) Slide the Left End tube onto the Center tube.
3) Pull the cable harness from the Main End cap through the length of the tube.
4) Slide the Right End tube onto the Center tube & pull the harness through its length.
5) Align holes in Center tube with holes in the Left & Right End tubes to adjust the overall length of the Watchman.
Pre-drilled holes provided equate to 10ft & 8ft, respectively. [Figure 1]
6) Insert the binding posts to secure the End tubes to the Center tube once desired length is achieved.
7) Plug the cable harness from the Main End cap into the Secondary End cap. [Figure 2]
8) Using a 5/32" hex wrench, secure Secondary End cap in place.
10ft
8ft
Weatherization Instructions
Apply silicone to the areas listed below to weatherize the Watchman:
1) Around the circumfrence of all hardware & unused holes along the length of the tube.
2) The seams between the Left / Right End tubes and Center tube.
Fig. 1
Fig. 1
Fig. 2
Fig. 2
