41
42
Place child restraint flush
against the back of the
vehicle seat forward-
facing in the back seat.
Fasten one UAS hook
on each anchor
bracket/bar located on
each side of the child restraint. See your vehicle
owner’s manual for locations.
5
continued on next page.
Forwar
d-Facing Child Restraint Installation with U
AS Belt:
10-18 kg (22-40 lb
.),
74-102 cm (29-40 in.)
2
Completed threading of
UAS forward-facing is
shown. DO NOT
twist belt.
When used in the
forward facing
position, the child
restraint MUST be
used in the upright
position.
3
4
If you are using this child
restraint without the
base, reach under the
seat and rotate the
recline stand down.
Push up firmly until it
locks in place.
Note:
If you were using the
UAS belt for a rear-facing
installation it must be
removed from the rear-
facing belt path before you
begin.
•
Do not use the vehicle
seat belt when using the
universal anchorage system
(UAS).
•
Check vehicle owner’s
manual for seat belt use
with a child restraint.
•
Do not use the level to ground line on the shoulder
belt positioning guide in the forward-facing position.
•
You may need to remove the base for narrow vehicle
seats or airline use (see “Removing Base” section).
Forward-Facing Child Restraint
Installation with UAS Belt
Insert UAS belt through
the forward facing belt
path pulling the hook with
the adjuster across the
back of shell and out the
other side.
UAS Belt
1
WARNING
!
For vehicles with an air bag, but without a
back seat, refer to your vehicle owners
manual.
4358-3434D Canada Elite Eng 3/17/08 9:05 AM Page 47
