EN - DORA METAL Spółka z o.o.
Chilling equipment
7
Make sure to fill the chilled space for the first time only after it is chilled to a work
temperature. Also follow this rule in the case of a longer shutdown.
Periodically it is recommended to have a shutdown of the device to clean its interior, ensure a natural
defrosting of the condenser and clean the condensing unit.
Before the above operations are carried out, make sure to turn off the device with power switch and
unplug the power cord from the wall socket.
To clean the condensing unit, remove ventilation grille from the encasing or the support structure.
Do not use water stream to clean the device
Make sure to clean the condensing unit
no less than once a month
. This should be carried out using a
soft brush or a vacuum.
The manufacturer cannot be held responsible for damage of the condenser resulting from
failure to keep the condenser clean!
All settings necessary for a normal operation of the device have been carried out by the manufacturer.
It is strictly forbidden to tamper with system parameters of the controller as this can have
very serious consequences, including damage of products and failure of chilling device.
The device is equipped with automatic condensate evaporation.
TRANSPORT
The manufacturer ships the device on a pallet, protected with card-board angles and foil. Make sure to
protect the device against moving before transport.
Transport the device in target working position. After reception of shipment (before unpacking) check if
there are no transport damages. If any damages are found, report them to the carrier immediately. In no
case should the damaged device be returned to the manufacturer without notice, and without his written
consent.
The manufacturer shall not be held responsible for the device damage during transport.
