Doosan G20 SIIIA, Operation & Maintenance Manual

Page: 31 / 122

31 G20, 30, 40 SIIIA Operation & Maintenance Manual
WARNING ALARM ICONS
Warnings are non-critical alarm conditions and do not affect the operation of the generator system. They serve to draw
the operator's attention to an undesirable condition.
By default, warning alarms are self-resetting when the fault condition is removed. However, enabling 'all warnings are
latched' will cause warning alarms to latch until reset manually. This is enabled using the DSE Configuration Suite in
conjunction with a compatible PC.
Additional warning alarm icons can be viewed overleaf.
ICON FAULT DESCRIPTION
Auxiliary Inputs
The module detects that an auxiliary input which has been
user configured to create a fault condition has become
active.
Analogue Input Configured As
Digital
The analogue inputs can be configured to digital inputs.
The module detects that an input configured to create a fault
condition has become active.
Fail To Stop
The module has detected a condition that indicates that the
engine is running when it has been instructed to stop.
NOTE: 'Fail to Stop' could indicate a faulty oil pressure
sensor. If engine is at rest, check oil sensor
wiring and configuration.
Charge Failure
The auxiliary charge alternator voltage is low as measured
from the W /L terminal.
Low Fuel Level
The level detected by the fuel level sensor is below the low
fuel level pre-set pre-alarm setting.
High Fuel Level
The level detected by the fuel level sensor is above the high
fuel level pre-set pre-alarm setting.
Battery Under Voltage
The DC supply has fallen below or risen above the low volts
pre-set pre-alarm setting.
Battery Over Voltage
The DC supply has risen above the high volts pre-set
pre-alarm setting.