DX380LC-7
Lifting Machine
1.
Refer to "Specification" section of this manual for weight
and dimensional information.
2.
Lower the work equipment to the ground as shown in the
diagram on the right.
3.
Lower the dozer blade to the ground. (if equipped)
4.
Move safety lever to "LOCK" position. Stop engine.
5.
Ensure there is nothing around the operator's
compartment, close the cabin door and front glass
securely.
6.
Bind wire ropes between the 1st and 2nd track rollers from
the front and between the 1st and 2nd track rollers from the
rear.
7.
Use spreader bars between the wire rope and the machine
to prevent damage to the rope or machine. Set the lifting
angle (1, Figure 14) of the wire rope to 30 - 40°.
8.
After the machine comes off the ground, check the hook
condition and the lifting posture, and then lift slowly.
EX1300751
1
1
Figure 14
WARNING
AVOID DEATH OR SERIOUS INJURY
Never lift the machine with a person in the cabin or on the
machine.
Never enter the area under or around a raised machine.
Improper lifting can allow load to shift and cause death or
serious injury or property damage.
When lifting, move the safety lever to "LOCK" position to
prevent the machine from moving unexpectedly.
Use only properly rated cables and slings.
Never go in the area under or around the machine when it is
raised.
Always use the posture given in the procedure below and
use the proper lifting equipment to lift the machine.
