DoorKing 2348, Owner'S Manual, Page: 10 / 53

1.4 System Requirements
The maximum number of elevator control systems that can be controlled from a DoorKing access
control system (1833, 1835, 1837, 1838) is eight. That is eight elevator cars (shafts) with each car
serving up to 64 floors. Each 2348-010 elevator control board can control up to 16 floors in a single
shaft, therefore a single elevator serving 64 floors requires the use of four (4) 2348-010 boards. If
two elevator cars (shafts) need to be controlled, with each car serving 32 floors, a total of four (4)
2348-010 boards would be required - two for each elevator car (shaft).
The table below determines the number of 2348-010 boards required to control the elevator system,
depending on the number of cars (shafts) and floors that are to be serviced.
Elevator Shafts
Floors
Car 1 Car 2 Car 3 Car 4 Car 5 Car 6 Car 7 Car 8
1-16 1 2 3 4 5 6 7 8
17-32 2 4 6 8 10 12 14 16
33-48 3 6 9 12 15 18 21 24
49-64 4 8 12 16 20 24 28 32
Table 2
The 2348-010 boards are housed in either a small (1816-102) or large (1816-100) cabinet. The small
cabinet will hold two 2348-010 boards, while the large cabinet will hold up to four boards. Each
elevator shaft requires either a small or large cabinet depending on the number of 2348 boards that
are required for the shaft.
The DoorKing elevator control system can only be used with a DoorKing model 1833, 1835 or 1837
telephone entry system, or with the DoorKing model 1838 multi-door access control system. A card
reader (or other access device) must be installed in the elevator car to allow building residents access
to floors as defined within the security level assigned to them. The system must be programmed with
a PC using the DoorKing Remote Account Manager for Windows software, version 5.0 or later.
Tracker expansion boards may be required depending on the number of doors and elevator cars
being controlled by the system.
Page 10 2348-065-D-12-07