background image

REVERSE
SENSITIVITY

POWER

1

ON

2

3

4

5

6

7

8

1

ON

2

3

4

5

6

7

8

NC NO

DOWN

LOOP

1 2 3 4 5 6 7 8

9

10 11 12 13

14

SW 1

SW 2

ON

OFF

AC POWER DC POWER

ON

AUTO

DOWN

UP

OFF

NO

NC

C

Wiring

Power

Transfor

mer

Yellow

Yellow - Common

Red+

Black-

Transformer Plug

C - Common - WHITE Wire

NC - Close - ORANGE Wire (Red LED)

NO - Open - GREEN Wire ( Green LED)

#9 - Reverse Edge

Keep wire
harness
clear of
all moving
parts.

MAKE SURE ALL POWER IS TURNED OFF TO OPERATOR!

Copyright 2019 DoorKing

®

, Inc. All rights reserved.

120 S. Glasgow Avenue

Inglewood, California 90301 

U.S.A.

Install Arm Cover

Wire harness 

MUST

 remain clear of the 

pivoting arm and the arm cover.

Arm Relay
Contacts

IMPORTANT: Wire harness MUST 
remain clear of the rotating arm and 
the arm cover to avoid wire chaffing.

DO NOT

 operate arm without a normally 

functioning reverse edge installed.

Arm Cover

3

1601-269-A-9-19

Summary of Contents for 1601-567

Page 1: ...raised LEDs turn GREEN and turns RED when lowered and remains RED in the down position Arm will reverse if lowering and a obstruction is encountered Note DO NOT operate arm without a normally functioning reverse edge installed Allow arm to protrude about 1 past the end of arm bracket Make sure arm cover fits over arm Arm Bracket Hub Arm Cover 14 Ft Arm Install Arm Hub MUST already be installed on ...

Page 2: ...Harness Secured to Top of Cabinet Included Adhesive Zip Ties Wire Guards Knock Out Knock Out Far Side Option Near Side Option Note for Older Operators A 5 8 hole will have to be drilled in the operator cabinet approximately where Knock Out is shown Make sure 5 8 hole is clear of all internal components Tip Liquid soap will help reverse edge slide on easier Use top hole in arm bracket to secure wir...

Page 3: ...en LED 9 Reverse Edge Keep wire harness clear of all moving parts MAKE SURE ALL POWER IS TURNED OFF TO OPERATOR Copyright 2019 DoorKing Inc All rights reserved 120 S Glasgow Avenue Inglewood California 90301 U S A Install Arm Cover Wire harness MUST remain clear of the pivoting arm and the arm cover Arm Relay Contacts IMPORTANT Wire harness MUST remain clear of the rotating arm and the arm cover t...

Page 4: ...ll need to have the reverse edge cut out of the existing cover Only one side of the cover will need to be cut out depending on which side the arm is mounted on Use this template as a guide to remove material from the cover 4 1601 269 A 9 19 ...

Reviews: