DoorHan DCUH-2, Owner'S Manual

Page: 8 / 16

8
6. PROGRAMMING
DIP switches are used to switch between the operating modes of the control unit board.
WARNING!

Prior to switching between the operating modes turn the power supply OFF.

When using the device for the first time make sure the DIP switches 1 and 2 are in correct position.
6.1. DIP SWITCHES
Table 6.1.1. DIP switches operation
DCUН-2 operating mode DCUН-3 operating mode
DIP 1 = Off DIP 1 = Off
DIP 2 = Off DIP 2 = On
DIP 3 is used to enter the advanced menu.
DIP 3 = Off (main menu)
DIP 3 = On (advanced menu) DIP 3 is used to enter the advanced menu.
DIP 3 = Off (main menu)
DIP 3 = On (advanced menu)
DIP 4 is not used DIP 4 is not used
Menu screen shows dH2 Menu screen shows dH3
In DCUH-2 mode each operation of the door and dock leveler is displayed on the menu screen accordingly (see Ta-
ble 6.1.2).
PROGRAMMING
* Connection scheme refers to DoorHan operators of Shaft series only.
Fig. 5.5. Connection scheme of lip inductive position sensor for DCUH-2 control unit*
Shaft operator
control post
Lip inductive
position sensor
Shaft operator control board terminals
brown
white
black
blue red
COM OPEN STOP CLOSE
+24V