DongFeng DFA1063DJ10-301, Service Manual

Page: 87 / 142

Suspension
SP-9
7.Assemble the U-bolt;
8.Lift the front axle by the jack, and then take down the
support of the frame then own the jack;
9.Tighten the U-bolts and nuts;
Tightening torque 200~250N · m
10.Install the damper to the bracket, then the plain washer,
spring washer and nut, then tighten them;
Tightening torque 140~170N
·
m
11.Add grease to the leaf spring pin and lifting eye pin as
required;
Assembly of the rear suspension
1.Smear a layer of grease on the spring bush and lifting eye
bush, and install the lifting eye to its bracket, then insert
lifting eye pin, then the cotter pin and tighten its lock
nut;
Tightening torque 90~110N · m
Note:When inserting the cotter pin, make the inclined
face contact to the face of lifting eye pin.
2.Set the rear spring to the rear axle, and lift the rear axle
by the jack;
3.Align the fixed end bracket hole to the spring eye, insert
the spring pin, then the cotter pin and tighten the nut;
Tightening torque 32~42N · m
Note:When inserting the cotter pin, make the inclined
face contact to the face of lifting eye pin.